論文 Evaluation of Residual Stress Distribution in Linear Friction Welded Steel Joint via Neutron Diffraction Mapping Measurement

Takayuki Yamashita ORCID ; Tomoya Nagira SAMURAI ORCID ; Wu Gong ORCID ; Takuro Kawasaki ORCID ; Stefanus Harjo ORCID ; Kohsaku Ushioda ORCID ; Hidetoshi Fujii ORCID

コレクション

引用
Takayuki Yamashita, Tomoya Nagira, Wu Gong, Takuro Kawasaki, Stefanus Harjo, Kohsaku Ushioda, Hidetoshi Fujii. Evaluation of Residual Stress Distribution in Linear Friction Welded Steel Joint via Neutron Diffraction Mapping Measurement. Tetsu-to-Hagane. 2025, 111 (17), TETSU-2025-042. https://doi.org/10.2355/tetsutohagane.tetsu-2025-042

説明:

(abstract)

In this study, neutron diffraction mapping was performed on linear friction welded joints of a 12 mm thick high-phosphorus weathering steel (SPA-H) to evaluate the distribution of residual stress, dislocation density and crystallographic orientation. Linear friction welding (LFW) was conducted under two different applied pressures (100 MPa and 250 MPa). The welded interface in both joints primarily consisted of refined ferrite, along with small amounts of retained austenite and martensite, suggesting that peak temperatures during welding exceeded the A1 point. However, the joint fabricated under 250 MPa exhibited a lower welding temperature. Grains were elongated along the oscillation direction (OD) at the specimen edges, while they were equiaxed at the center. Additionally, inhomogeneous microstructural distributions were observed near the interface along OD. Both joints exhibited high tensile residual stresses in all directions at the center of welding interface, whereas compressive residual stresses were introduced along the longitudinal direction (LD) near the surface in the OD. The applied pressure had minimal influence on the overall trend of the residual stress distribution within the tested welding conditions. Dislocation density was elevated at the weld interface compared to the base metal, with a more pronounced increase under the higher applied pressure. This is attributed to suppressed dynamic recovery caused by the lower welding temperature at higher pressure. Finally, strong texture formation was observed at the welding interface due to plastic flow during welding. The applied pressure had only a limited effect on texture development.

権利情報:

キーワード: Linear friction welding, neutron diffraction, residual stress

刊行年月日: 2025-12-15

出版者: Iron and Steel Institute of Japan

掲載誌:

  • Tetsu-to-Hagane (ISSN: 00211575) vol. 111 issue. 17 TETSU-2025-042

研究助成金:

原稿種別: 出版者版 (Version of record)

MDR DOI:

公開URL: https://doi.org/10.2355/tetsutohagane.tetsu-2025-042

関連資料:

その他の識別子:

連絡先:

更新時刻: 2025-12-15 15:16:15 +0900

MDRでの公開時刻: 2025-12-19 14:11:37 +0900

ファイル名 サイズ
ファイル名 山下_鉄と鋼_Vol.111 No.17_1057-1071.pdf (サムネイル)
application/pdf
サイズ 12.3MB 詳細